When it comes to building the Rubik’s Cube, it’s not as hard as it looks. In all actuality, it will take about fifteen minutes and the instructions are easy to follow. When it comes to placing the colored tiles, make sure you pay attention to where you’re supposed to place them, because if you snap them in the wrong place, you won’t be able to remove them. Yes, you will still be able to use the Rubik’s Cube, but you won’t be able to follow along with the instruction guide on solving the puzzle.
Since the center pieces cannot be moved relatively to each other it's important to solve the edge pieces correctly in relation to each other. For example, when solving the white in our case- the green center piece is to the left of the red center piece, therefore the green-white edge piece should to be solved to the left of the red-white edge piece (see image).
We add the BrickPi3 to the LEGO assembly.  We used the LEGO EV3 “wings” to support the BrickPi3 and make it level with the BricKuber body.  This is a good step to add 8XAA batteries to the power pack and attach the BrickPi3 power pack to the LEGO assembly.  For programming you can power the BrickPi3 via USB power to the Raspberry Pi, however to move the motors you will need to supply power with the Power Pack.        
Since the center pieces cannot be moved relatively to each other it's important to solve the edge pieces correctly in relation to each other. For example, when solving the white in our case- the green center piece is to the left of the red center piece, therefore the green-white edge piece should to be solved to the left of the red-white edge piece (see image).
Simply put the 1x1x3 is a pseudo puzzle, It fills a gap in the collection but its not exactly complicated to solve. The way this puzzle was made was by using two centres and a core of a QiYi Sail. As these parts already spin like a 1x1x3 should all I had to do was make these parts into cubies by adding some apoxie sculpt and sanding them smooth. This puzzle was made in an afternoon and stickered the following morning while I was also building my 'Mefferts bandage cube'. Rubix Building Products

If there are no more edges left on the top layer, then they are probably either inserted in the right place but flipped, or inserted in the wrong place. To get an edge out of somewhere it shouldn't be, just insert one of the yellow edges into that slot. This should get the edge out and on the top layer, ready for you to use the above instructions to insert correctly. Rubix Build

×