Sport, Outdoor & Furniture Kids Furniture Sand Toys, Pools & Inflatables Kids Sports & Balls Trampolines & Playgyms Blasters & Water Pistols Vehicles Hobbies & Radio Controlled Remote Control Collectible Vehicles Slot Cars & accessories Model Trains & accessories Model Kits Vehicles & Play Sets STEM STEM - Science STEM - Technology STEM - Engineering STEM - Mathematics
We add the BrickPi3 to the LEGO assembly.  We used the LEGO EV3 “wings” to support the BrickPi3 and make it level with the BricKuber body.  This is a good step to add 8XAA batteries to the power pack and attach the BrickPi3 power pack to the LEGO assembly.  For programming you can power the BrickPi3 via USB power to the Raspberry Pi, however to move the motors you will need to supply power with the Power Pack.        
Twist the bottom layer so that one of the white corners is directly under the spot where it's supposed to go on the top layer. Now, do one of the three algorithms according to the orientation of the piece, aka. in which direction the white sticker is facing. If the white corner piece is where it belongs but turned wrong then first you have to pop it out.
The quality of the individual parts are also inspected just after exiting the mold. Since thousands of parts are made daily, a complete inspection would be difficult. Consequently, line inspectors may randomly check the plastic parts at fixed time intervals and check to ensure they meet size, shape, and consistency specifications. This sampling method provides a good indication of the quality of the overall Rubik's cube production run. Things that are looked for include deformed parts, improperly fitted parts and inappropriate labeling. While visual inspection is the primary test method employed, more rigorous measurements may also be performed. Measuring equipment is used to check the length, width, and thickness of each part. Typically, devices such as a vernier caliper, a micrometer, or a microscope are used. Just prior to putting a cube in the packaging it may be twisted to ensure that it holds together and is in proper working order. This can be done by hand or by a turning machine. If a toy is found to be defective it is placed aside to be reworked later.
2 After the cube parts are ejected from the mold, they are dropped into container bins and hand inspected to ensure that no significantly damaged parts are used. The waste sprue material is set aside to be reused or scrapped. Waste material can be ground up and melted again to make new parts, however reground material can degrade and cause poor quality parts. Rubik's cubes are always made from virgin material and never use reground waste plastic.

Simply put the 1x1x3 is a pseudo puzzle, It fills a gap in the collection but its not exactly complicated to solve. The way this puzzle was made was by using two centres and a core of a QiYi Sail. As these parts already spin like a 1x1x3 should all I had to do was make these parts into cubies by adding some apoxie sculpt and sanding them smooth. This puzzle was made in an afternoon and stickered the following morning while I was also building my 'Mefferts bandage cube'.
If there are no more edges left on the top layer, then they are probably either inserted in the right place but flipped, or inserted in the wrong place. To get an edge out of somewhere it shouldn't be, just insert one of the yellow edges into that slot. This should get the edge out and on the top layer, ready for you to use the above instructions to insert correctly. Rubix Build
×