You can find assembly instructions for the BrickPi3 here. We will need to assemble the case, attach the BrickPi3, the Raspberry Pi, the Raspberry Pi Camera, add an SD Card, and add batteries.  To make the software easier to setup, Raspbian for Robots comes with most of the software you will need already setup.  You will need at least an 8 GB SD Card, and you will want to expand the disk to fit the full size of the SD Card. Rubix Builders
For decorative purposes, a colorant is typically added to the plastic. The pieces of a Rubik's cube are typically black. During production, colored stickers are put on the outside of the cube to denote the color of a side. The plastics that are used during production are supplied to the manufacturer in a pellet form complete with the filler and colorants. These pellets can then be loaded into the molding machines directly.
The manufacture of the first Rubik's cube prototypes was by hand. During the late 1970s, methods for mass production were developed and continue to be used today. Typically, production is a step by step process that involves injection molding of the pieces, fitting the pieces together, decorating the Rubik's cube, and putting the finished product in packaging. Rubix Building Products
4 Next, the Rubik's cube faces need to be labeled. The labels are made from sheet polypropylene material that is printed with the colors. The printed sheet PP is then laminated with a clear PP protective covering. The material is then die cut with the labels wound onto rolls. The labels are made with all nine squares of each face exactly aligned. This way the labels can be perfectly aligned when they are applied to the cube.
Keeping white on top, turn the cube so that a different colour face is toward you. Follow the above instructions again. Repeat with the other two faces until the white cross is complete. This step is quite intuitive; you can do it for sure but it does take a little practice. Just move the white edges to their places not messing up the ones already fixed.  

If you were around in the 1980’s and did not live under a rock, you had a Rubik’s cube.  It was the 3D combination puzzle that had children and adults mesmerized trying to solve the impossible puzzle.  We would spend hours twisting and turning the cube to figure the solution. The cube was invented by an Hungarian professor of architecture, Erno Rubik, in 1974.  Although it took Erno over one month to solve his very own puzzle, it  became a fad and everyone had one. Consequently, it became the world’s best selling toy ever at that time.
An important thing to note is that this task is not a light one. It may require several hours of attempts. If you'd rather just solve the cube in your hand and forget about it rather than being able to solve any cube you're given, there are plenty of solvers available on the web. However, the satisfaction of holding a completed Rubik's Cube in your hand and thinking “I did that, and I can do it again” is greater than most, mainly due to the fact that the puzzle has been present in all our lives at some point. By the mid 1980's, an estimated fifth of the world's population had attempted to solve the cube. If you want to stand out and say that you can defeat the puzzle, time and determination is a large factor. Rubix Build
×