Begin with your cube solved. Once again, you want to start off with your Rubik’s cube in its solved position. Making a fish pattern on your Rubik’s cube is simple. The end result will have swapped two edge pieces so that the remaining ones look like a fish with fins. If you hold the cube diagonally it will look like a fish swimming away from you.[7] Rubiks Build It Solve It

Headlights are fairly simple to spot. Looking at the image, we can see on the right hand side that the orange edge has a green corner on either side of it. That is a set of headlights. The left hand side has two different colours on either side, so that is not a set of headlights. It is very important to note that a full bar (a blue edge has a blue corner on either side of it, so all three pieces are blue) is also seen as a set of headlights. This is only seen in one case of the 21 though, so you won't see it often. If you have a set of headlights on each side, ignore this part and read the section titled “The U Permutation”.
Begin with your cube solved. Once again, you want to start off with your Rubik’s cube in its solved position. Making a fish pattern on your Rubik’s cube is simple. The end result will have swapped two edge pieces so that the remaining ones look like a fish with fins. If you hold the cube diagonally it will look like a fish swimming away from you.[7]
The robot will turn the cube to each face and the camera will take 6 pictures, one of each side of the Cube.  The Raspberry Pi will determine the cube configuration from the six pictures. The Cube configuration will be passed to the kociemba Python library to find an efficient solution. Finally, the robot will execute the moves to solve the Rubik’s Cube!
1 When production is initiated, the plastic pellets are transformed into Rubik's cube parts through injection molding. In this process, the pellets are put into the hopper of an injection molding machine. They are melted when they are passed through a hydraulically controlled screw. As the screw turns, the melted plastic is shuttled through a nozzle and physically forced, or injected, into the mold. Just prior to the arrival of the molten plastic, the two halves of the mold are brought together to create a cavity that has the identical shape of the Rubik's cube part. This could be an edge, a corner, or the center piece. Inside the mold, the plastic is held under pressure for a specific amount of time and then allowed to cool. While cooling, the plastic hardens inside the mold. After enough time passes, the mold halves are opened and the cube pieces are ejected. The mold then closes again and the process begins again. Each time the machine moulds a set of parts is one cycle of the machine. The Rubik's cube cycle time is around 20 seconds. Rubiks Build It Solve It Instructions
An important thing to note is that this task is not a light one. It may require several hours of attempts. If you'd rather just solve the cube in your hand and forget about it rather than being able to solve any cube you're given, there are plenty of solvers available on the web. However, the satisfaction of holding a completed Rubik's Cube in your hand and thinking “I did that, and I can do it again” is greater than most, mainly due to the fact that the puzzle has been present in all our lives at some point. By the mid 1980's, an estimated fifth of the world's population had attempted to solve the cube. If you want to stand out and say that you can defeat the puzzle, time and determination is a large factor. Rubix Build
×