Using the LEGO Camera support, attach the camera.  The small black lens of the camera should fit between the two LEGO beam supports.  Secure the camera in place to the LEGO supports with some electrical tape.  This is a good time to make sure that the camera is position to be able to capture the entire Rubik’s cube.  You can take a test picture with the raspistill command Rubiks Build It Solve It Review
If there are no more edges left on the top layer, then they are probably either inserted in the right place but flipped, or inserted in the wrong place. To get an edge out of somewhere it shouldn't be, just insert one of the yellow edges into that slot. This should get the edge out and on the top layer, ready for you to use the above instructions to insert correctly. Rubix Build
×